• Multicrown gearing with continuous sleeve
• Torque up to 348.000 Nm+
• Bore diameter up to 290 mm+
   

The escogear C & C-M series couplings are torsionally rigid grease filled couplings consisting of two hubs with external crowned - and one single sleeve with two pairs of straight internal teeth on each sleeve end, a so-called continuous sleeve. Both sleeve ends are sealed.

These are the most compact gear coupling designs. The teeth of hub and sleeve are continuously in contact with each other and have been designed with the necessary backlash to accommodate angular-, parallel- and axial misalignment within their misalignment capacity. The angular and parallel misalignment capacity is determined by the gear tooth design and is for the standard escogear max. 1.5° degrees (2 x 0.75°) in total. The axial misalignment capacity is limited by the gear teeth length in the sleeve and can be varied (optionally - for C-M series only).

Gear couplings are generally made from carbon steel Ck45 (AISI 1040). For higher torque capacities, within the same coupling dimensions, a higher alloy steel as 42CrMo4QT can be used (optionally). The escogear C & C-M series are substantially lighter in weight than the escogear F-series. These compact designs make the escogear C & C-M series ideal for use in applications where space is limited, and weight is important. Two versions are available. The C for bores up to 110 mm and the C-M configuration for larger bores.
 

Special properties

• Multicrown gearing
• Homogeneous torque transmission
• Reduced backlash
• Optimum max. torque-/ max. misalignment-ratio
• Optimum flange connection
• Excellent protection of components
• Most compact solution
• Continuous sleeve
• Turnable Hubs
• Vertical and horizontal installation
• Standard and special-purpose versions
• Numerous designs
• Available from stock (pre-bored)
• 14 sizes